- #CAREL SMART REFRIGERATION CONTROLLER HOW TO#
- #CAREL SMART REFRIGERATION CONTROLLER PASSWORD#
- #CAREL SMART REFRIGERATION CONTROLLER SERIES#
#CAREL SMART REFRIGERATION CONTROLLER PASSWORD#
7.5.1 The PSW button: enter the system password from the remote control Pressing the PSW button for at least 5 seconds accesses the enter prompt for the. 2.0 dated 25/06/01 16 7.5 The PSW button and the command buttons. 2.0 dated 25/06/01 15 7.3 Technical specifications Power supply 2 alkaline batteries, 1.5V (type UM-4 AAA, IEC R03) Case plastic Dimensions 60x160x18mm Storage -25Â☌ÃĬod. Programming by remote control (AVAILABLE FOR THE FOLLOWING MODELS: IRMPX0A000, IRMPX1A000, IRMPXMA000) 7.1 Remote control layout (I): Function buttons History, PSW, ESC, ENABLE.
#CAREL SMART REFRIGERATION CONTROLLER HOW TO#
2.0 dated 25/06/01 13 How to exit the procedure How to save the new set values • Press to save the new values and exit the procedure. To simplify this operation, we have divi.Ĭod. Programming The microprocessor in the MPX instruments allows the configuration of the functions of the controller according to the application requirements. In any case, the maximum defrost time is equal to the value, in minutes, set.Ĭod. 2.0 dated 25/06/01 11 dt: End defrost temperature This parameter allows the end defrost temperature, as measured on the evaporator, to be set. 2.0 dated 25/06/01 10 5.3 Other important parameters LAN configuration parameters: For the Master: • parameter “Sn†(Slave number): from 1 to 5 number of Slaves in the LAN during boot the display shows “uMâ.Ĭod. They have in fact been programmed using a default configuration so as to satisfy the more common requirements. The multiplexed units are supplied ready for use. 2.0 dated 25/06/01 8 ( - stops the audible alarm for 10 minutes(only if fitted) if pressed for over 5 seconds: - accesses the menu of the type “F†parameters (frequent) if pressed for more than 5 secon.Ĭod.
User interface - Buttons and display Each instrument features: • 12Vac power supply • two and a half digit display • temperature display to the tenths • LED indicating the output.Ĭod.
Installation Actual installation: 1) insert the instrument into the previously-created opening 2) fasten the instrument to the panel by sliding it onto the fastening bracket. The table below lists the various codes and the corresponding options that characterise ea.Ĭod.
#CAREL SMART REFRIGERATION CONTROLLER SERIES#
The models in the MPX series have different codes according to their features. If the FAN relay is not used to control the fans it can be used as an. 2.0 dated 25/06/01 4 Multifunction output A fourth relay is present to remote the alarm signal or to control the On/Off command of accessory devices. 2.0 dated 25/06/01 3 General Features The multiplexed Master/Slave units belong to the MPX Series for refrigeration, made up of microprocessor-controlled electronic controllers with LED display, specifically designed for.Ĭod. Main features of the multiplexed Master/Slave units.Ĭod.
0 kommentar(er)
